Today, we will tell you the reason why your key cutting is not accurate and the correct operation method to cut a key accurate.
Solution:
A. After you receive new machine or the machine has been used for a period of time, please re-calibrate the machine in order to ensure the cutting accuracy. Usually once a month but it’s up to the frequency you use your machine.
B. Once you reset the distance between the decoder and cutter, all the clamps should be re-calibrated.
C. If you have replaced the main board or upgraded the firmware, please do all the calibration procedures
D. Be sure to clean the clamps, keep it free of metal shavings.
Calibration Method:
Please use the original decoder, cutter and calibration block and follow the calibration steps as below
video:
Main Reasons:
A. non-original decoder and cutter
B. Decoder and cutter used too long time and didn’t replace them regularly.
Solution:
A. The original decoder and cutter is critical to life of the E9 Key Cutting Machine and key cutting accuracy. Please use the original decoder and cutter, we will not responsible to any problems caused by user who uses a non-original decoder and cutter.
B. When the cutter is blunt or cut a key with burr, please replace a new cutter promptly, and don’t use it any more, in case of fracture or personnel injury.
Solution:
Do calibration with correct calibration method, adjust the correct cutting speed, and select the corresponding sensing key location to cut a key.
Below is the different sensing key locations for different keys to cut:
Solution:
A. flat milling key placed on the upper layer.
B. laser keys placed on the lower layer.
C. the key should be placed smoothly, tighten the clamp
Solution:
When you copy a key but the original key has been used a long time and gets a lot of wear and tear, in this case you should cancel the choice of “round” when you decoding the original key, then cut a new key.
Solution:
Please refer to below appropriate choice of clamps for different key cutting.